Removing rear variator - need help

lubba · Post by **lubba** » Thu 20 May 2010, 01:06

I'm trying to remove the rear variator, but I'm not sure how to do it.
I've removed the nut mounted on the top (as the pictures show), but what's next?
I've also tried what the last picture is showing, but it didn't work. Please help me.

Remko · Post by **Remko** » Thu 20 May 2010, 07:47

Try using some very thin oil and slapping it with a hammer.

lubba · Post by **lubba** » Thu 20 May 2010, 09:33

Thank you for your reply.
I did, using a rubber hammer like on the picture.
So it's just stuck because of rust and aging, and not because of other nuts, screws etc.?

Remko · Post by **Remko** » Thu 20 May 2010, 11:05

Nope, I would try to support it on one side with something heavy, so that you do not damage the bearings (!!!), and give it a good wack with a steel hamer.

killingsnake · Post by **killingsnake** » Thu 20 May 2010, 16:15

The propper way to do it:

Get a honda (or replica) pulley remover. If you look on the space where the nut sits in, you can see a thread. You attach the pulley remover at that thread, then turn the bolt inside, wich presses against the axis and pulls the pulley loose.

If you have a lathe at your disposal, you can easely make your own.

Post by **GoBieN** » Thu 10 Jun 2010, 19:31

Like this:
[album]528[/album]

Twister · Post by **Twister** » Thu 10 Jun 2010, 19:50

It will probably not work as the thread on the pulley seems damaged (actually, on the picture it seems to be completely missing)

HondaCaminoTuning.be

Please disable your adblocker on this website!
The website costs are covered by using ads that are non-intrusive. Please whitelist this domain in your adblocker software or plugin. Thank you.

Schakel alstublieft de adblocker uit!
De kosten van het hosten van de website worden betaald met advertentie-inkomsten. Voeg alstublieft een uitzondering toe voor dit domein in de software of plugin.