PX-R new cilinder, clean carb and gas tank, new rollers, new CDI, still slow.

ooo · Post by **ooo** » Thu 20 Jul 2023, 21:08

I am restoring a Honda PX-R, but I can’t get it to work properly.

I have put on a new cilinder and piston, new CDI unit (that caused it to start), I cleaned the carb, cleared all rust from the gas tank and put new rollers in, but it still only goes 10km/h max.

What else could be the problem? I do note that there is a lot of noise coming from where the v string, rollers and clutch are (idk the English word that that section haha). Any suggestions are welcome!

Post by **camino_expert** » Wed 26 Jul 2023, 14:46

hello
you changed the variorollers ?

measure please ?
wheigt of them ?
what for ramp vario plate do you got flat or bowed ?

i think px has 13x16 like honda wallaroo
you can change also the varioplate
for px B kl 40 ph
rear to find
but the wallaroo stars white a little adaption can also be fitted S72 star is most bowen , i think org for older model honda vision
i think stil to buy
good luck and succes
best regards

HondaCaminoTuning.be

Please disable your adblocker on this website!
The website costs are covered by using ads that are non-intrusive. Please whitelist this domain in your adblocker software or plugin. Thank you.

Schakel alstublieft de adblocker uit!
De kosten van het hosten van de website worden betaald met advertentie-inkomsten. Voeg alstublieft een uitzondering toe voor dit domein in de software of plugin.